1. LINES, LETTERING, DIMENSIONING, COPYING FIG.
2. SCALES: Plain scales, Diagonal scales, Comparative scales, Vernier scales
3. GEOMETRICAL CONSTRUCTION AND CURVES
Dividing of lines and angles in equal sectors, Construction of
polygons, Polygons inscribed in circles, Parabola, Hyparabola,
Ellipse, Cycloid, Involute, Archemedian spiral
4. PROJECTION OF POINTS, LINES, SURFACES
Orthographic Projection – First angle and third angle projection
More no. of problems should be practiced in first angle projection.
Projection of lines inclined to the planes
Projection of surfaces
Pentagon, Hexagon
5. PROJECTION OF SOLIDS
Cube, Pyramid, Prism, Cylinder, Cone, Frustums
6. Verification of Superposition theorem
7. Calibration of ammeter and voltmeter.
8. Study of R-L-C Series circuit
9. Study of R-L-C parallel circuit
10. Open circuit and Short circuit test of a single phase Transformer.
11. No load characteristics of D.C shunt Generators
12. Starting and reversing of speed of a D.C. shunt
13. Speed control of DC shunt motor.
14. Measurement of power in a three phase circuit by two wattmeter method.
