1. Study of prewritten programs on trainer kit using the basic instruction set (data transfer,
Load/Store, Arithmetic, Logical) Assignments based on above.
2. a) Familiarization with 8085 simulator on PC.
Study of prewritten programs using basic instruction set (data transfer, Load/Store,
Arithmetic, Logical) on the simulator. Assignments based on above
3. Programming using kit and simulator for:
i) Table look up
ii) Copying a block of memory
iii) Shifting a block of memory
iv) Packing and unpacking of BCD numbers
v) Addition of BCD numbers
vi) Binary to ASCII conversion
vii) String Matching Multiplication using Booth’s Algorithm
4. Program using subroutine calls and IN/OUT instructions using 8255 PPI on the trainer
kit e.g. subroutine for delay, reading switch state and glowing LEDs accordingly.
5. :Study of timing diagram of an instruction on oscilloscope..
6. Interfacing of 8255: Keyboard and Multi-digit Display with multiplexing using 8255
7. Study of 8051 Micro controller kit and writing programs for Interfacing of Keyboard,
DAC and ADC using the kit.
8. Serial communication between two trainer kits