1. Design & implementation of diode clipping circuits.
2. Design & implementation of diode clamping circuits.
3. Design & implementation of 2-stage R-C coupled transistor amplifiers & to measure the gain &
bandwidth.
4. Design & implementation of the class A & class B power amplifiers(using transistors) to measure
the efficiency & distortion (using power & distortion meter).
5. Design & implementation of of the class C & push-pull amplifiers(using transistors) to measure
the efficiency & distortion (using power & distortion meter).
6. Design & implementation of differentiator & integrator using OP-AMP(IC 741).
7. Design & implementation of adder & subtractor using OP-AMPS(IC 741)
8. Design & implementation of of monostable & astable multivibrator using NE555 timer.
9. Design & implementation of bistable multivibrator using NE555 timer.
10. Design of a simple function generator(Sawtooth,sine wave, ramp etc.) using OpAMPs(IC 741) to
observe the waveform on CRO.
11. Design & implementation of a V-to-I & I-to-V converter using OPAMPs.
12. Study the signal patterns at different test point of a switched mode power supply circuit & to
measure the voltage regulation.
13. One innovative experiment.