1. Study the characteristics of SCR.
1.1 Observe the terminal configuration.
1.2 Measure the breakdown voltage.
1.3 Measure latching and holding current.
1.4 V-I characteristics.
2 Perform experiment on triggering circuits for SCR.
2.1 R-triggering circuit.
2.2 R-C triggering circuit.
2.3 UJT triggering circuit.
3 Study and obtain the characteristics of Diac.
4 Study and obtain the waveforms for single-phase half-wave controlled converter.
5 Study and obtain the waveforms for single-phase half controlled symmetrical and asymmetrical bridge
converters.
6 Study and obtain the waveforms for single-phase fully controlled bridge converter.
7 Study and obtain the waveforms for voltage-commutated chopper.
8 Study and obtain the waveforms for current-commutated chopper.
9 Perform experiment on single phase PWM inverter.
10 Perform experiment on buck, boost and buck-boost regulators.
11 Perform experiment on Motor control – open loop & closed loop.