1. To study input- output characteristics of a potentiometer and to use two potentiometers as an
error detector.
2. To study transmitter- receiver characteristics of a synchro set to use the set as control
component.
3. To study the operation of a d-c positional servo system and to investigate the effect of
damping and supply voltage on its response.
4. To study the operation of an a.c. position servo-system and to obtain effects of supply voltage
and system parameter on its transient response.
5. To design different compensation network for the given cut off frequencies and to plot
frequency response of these networks.
6. To use operational amplifiers as multiplier, summer, inverter and integrator.
7. To simulate a servo-system and obtain its characteristics with the use of controllers.
8. To study control action of light control device.
9. To study details of a magnetic amplifier and to obtain input-output characterization of thisamplifier.
10. To study details of a two winding a-c servometer and to obtain its T-N characteristics.
11. To study PID- controller and to obtain the effect of proportional, integral and derivative
control action.
12. To study details of an analog computer and solve a given second order differential equation
using it.
13. To generate a sine-wave using a given analog computer with specified amplifier and
frequency.
14. To study a stepper motor and control its direction speed and number of steps with the held of a
microprocessor.
15. To obtain dynamic characteristics of a given solar cell array and to obtain the point of
operation for maximum power transfer to the load.
16. To obtain T.F. of a field controlled d.c. servometer and to show its pole-zero configuration.
17. To obtain T.F. of an armature controlled d.c. servometer and to obtain its pole zero
configuration.
18. To design, fabricate and to obtain characteristics of a high pass T type filter.
19. To design, fabricate and to obtain characteristics of low pass T type filter.
20. To design, fabricate and to obtain characteristics of band pass T type filter.
21. To design, fabricate and to obtain the characteristics of a composite low pass filter.
22. To design, fabricate and to obtain the characteristics of a composite high pass filter.
23. To design, fabricate and to obtain the characteristics of composite band pass filter.