1. (a) Verification of the truth tables of TTL gates, e.g., 7400, 7402,7404, 7408, 7432,7486.
(b) Design, fabrication and testing of low frequency TTL clocks using NAND gates.
2. (a) Verification of the truth table of the Multiplexer 74150.
(b) Verification of the truth table of the De-Multiplexer 74154.
3. Design and verification of the truth tables of half adder and full adder circuits using gates 7483.
4. Study and verification of the operations of ALU 74181 with regards to addition/
subtraction / comparison.
5. Design fabrication and testing of differentiator and integrator circuits using OP AMP.
6. Design fabrication and testing of clipper and clamper circuits using OP AMP.
7. Design fabrication and testing of
(a) Monostable multivibrator of t=0.1 msec.approx.) using 74121/123. Testing
for both positive and negative edge triggering, variation in pulse with and
retriggering.
(b) Free running multivibrator at 1 KHz and1 Hz using 555 with 50% duty
cycle. Verify the timing from theoretical calculations. 8. Design fabricate
and test a switch debouncer using 7400.
9. (a) Design and test of an S-R flip-flop using TOR/NAND gates.
(b) Verify the truth table of a J-K flip-flop (7476)
(c) Verify the truth table of a D flip-flop (7474) and study its operation in the
toggle and asynchronous modes.
10. Operate the counters 7490, 7493 and 74192. Verify the frequency division at
each stage. With a low frequency clock (say 1 Hz) display the count on LEDs.
11. (a) Verify the truth table of decoder driver 7447 / 7448. Hence operate a 7
segment LED display through a counter using a low frequency clock.
(b) Repeat the above with the BCD to Decimal decoder 7442 and an array of LEDs.