6. Measurements using Optical Projector / Toolmaker Microscope.
7. Measurements of angle using Sine Center / Sine bar / bevel protractor
8. Measurements of alignment using Autocollimator / roller set
9. Measurements of cutting tool forces using
a) Lathe tool Dynamometer
b) Drill tool Dynamometer.
10. Measurements of Screw thread Parameters using two wire or three-wire
method.
11. Measurements of Surface roughness. Using Tally surf/mechanical
Comparator.
12. Measurements of gear tooth profile using gear tooth vernier /gear
tooth micrometer.
13. Calibration of micrometer using slip gauges
14. Measurement using Optical Flats |