1. Design an Inverter with given specifications*, completing the design flow
mentioned below:
- Draw the schematic and verify the following
- DC Analysis
- Transient Analysis
- Draw the Layout and verify the DRC, ERC
- Check for LVS
- Extract RC and back annotate the same and verify the Design
- Verify & Optimize for Time, Power and Area to the given
constraint***
2. Design the following circuits with given specifications*, completing the
design flow mentioned below:
a. Draw the schematic and verify the following
i) DC Analysis
ii) AC Analysis
iii) Transient Analysis
b. Draw the Layout and verify the DRC, ERC
c. Check for LVS
d. Extract RC and back annotate the same and verify the Design.
i) A Single Stage differential amplifier
ii) Common source and Common Drain amplifier
3. Design an op-amp with given specification* using given differential
amplifier Common source and Common Drain amplifier in library** and
completing the design flow mentioned below:
a. Draw the schematic and verify the following
i) DC Analysis
ii). AC Analysis
iii) Transient Analysis
b. Draw the Layout and verify the DRC, ERC
c. Check for LVS
d. Extract RC and back annotate the same and verify the Design.
4. Design a 4 bit R-2R based DAC for the given specification and
completing the design flow mentioned using given op-amp in the library**.
a. Draw the schematic and verify the following
i) DC Analysis
ii) AC Analysis
iii) Transient Analysis
b. Draw the Layout and verify the DRC, ERC
c. Check for LVS
d. Extract RC and back annotate the same and verify the Design.
5. For the SAR based ADC mentioned in the figure below draw the mixed
signal schematic and verify the functionality by completing ASIC Design
FLOW.
* Appropriate specification should be given.
** Applicable Library should be added & information should be given to
the Designer.
*** An appropriate constraint should be given