06ESL37 - Analog Electronics Lab Regulation 2006 - 2007 |
1. Wiring of RC coupled Single stage FET & BJT amplifier and
determination of the gain-frequency response, input and output impedances.
|
2. Wiring of BJT Darlington Emitter follower with and without bootstrapping
and determination of the gain, input and output impedances (Single circuit)
(One Experiment)
|
3. Wiring of a two stage BJT Voltage series feed back amplifier and
determination of the gain, Frequency response, input and output impedances
with and without feedback (One Experiment)
|
4. Wiring and Testing for the performance of BJT-RC Phase shift Oscillator for f0 ≤10 KHz.
|
5. Testing for the performance of BJT – Hartley & Colpitts Oscillators for RF range f0 ≥100KHz.
|
6. Testing for the performance of BJT - Crystal Oscillator for f0 > 100 KHz.
|
7. Testing of Diode clipping (Single/Double ended) circuits for peak clipping,
peak detection.
|
8. Testing of Clamping circuits: positive clamping /negative clamping
|
9. Testing of a transformer less Class – B push pull power amplifier and
determination of its conversion efficiency.
|
10. Testing of Half wave, Full wave and Bridge Rectifier circuits with and
without Capacitor filter. Determination of ripple factor, regulation and
efficiency
|
11. Verification of Thevinin’s Theorem and Maximum Power Transfer
theorem for DC Circuits.
|
12. Characteristics of Series and Parallel resonant circuits.
|